-
Installed tado
Hi I have installed tado. When I put heating on and then turn it off from the app it doesn't seem to go off
-
life of Tado servers?
Hi guys Enjoying my recently installed wireless V3 smart stat. I assume any commands I send to the V3 unit by Alexa, wireless stat etc have to go via the Tado servers so what happens if these servers stop for whatever reason eg. change of business model, change of Tado ownership or whatever will WiFi still work or just the…
-
Request to heat one radiator is not firing up the boiler, any ideas why?
Hi, I recently installed 2x Tado wired thermostats to replace existing wired thermostats as the heating is split into two zones - 1x upstairs and 1x downstairs. I have also installed the smart TRV's on all radiators, except for the living room which was the radiator selected to permanently leave on. Yesterday, I noticed…
-
Eneloop batteries worth it?
Hey all As the title, really. I current use mostly Energiser rechargeable batteries but I don’t seem to very long out of them so I’m looking to get the batteries Tado recommends. So, as they are expensive, I’d like to gauge if the cost is worth it. If so, is it worth getting the Eneloop charger too or will any do? Thanks
-
Boosting a rad.
I get you can increase the temp on any given radiator if off but can you set it to boost for say 30mins or an hour then it goes off after this set time?
-
Why is one smart radiator controlling the whole house?
I’ve got a whole house system with a wall attached central thermostat which worked well. But then we had some work done and one of the rooms became one we used much more and also significantly colder. I bought a smart radiator valve with the idea of heating that room only. But it turns on the whole house. What am I doing…
-
tado and Viessman integration issues
Hello all, I have an installation of both a wired thermostat and wireless extension thermostat mated to a Viessman v100 boiler. My home has two heating zones plus hot water all controlled by Tado. The issue that im am having is that i can only activate one of the heating zones when the hot water is activated. I can see the…
-
Hot Water on Wired thermostat
Hi all. Moving home - new house has a conventional system with a hot water tank. It uses a wired TPOne-M thermostat located in the hallway which controls the heating and also the hot water from the same device. No timer or any other controls in the cupboard with the tank. Question is, can I replace the TPOne-M with a wired…
-
Anyone else think it disgusting that Tado now make you subscribe to get the basic features
Are Tado getting it wrong?
-
Extension kit VS Wireless non-UK
Good afternoon, we have recently move to a property that has a Worcester Greenstar 4000 boiler installed. I have a Tado V3+ wireless system purchased outside the UK with opentherm and an extension kit. Per the app both are compatible with my boiler and wondering which one would provide the best performance. I've read…
-
New to Tado. Spanner and Overheating
We had Tado installed yesterday so I am trying to familiarise myself with it. I am unable to attach a photo but one of the valves shows a spanner on it and the radiator is overheating at 25 when I have tried putting both the app and the thermostatic valves at 15. There is also an image of a spanner on the valve. What does…
-
No hot water
Hey all, I'll try to keep it brief - I am (slowly) trying to resolve the issue with support but figured I would also ask here in case anyone has suggestions or quick fixes. Background: New tado user, new install. UK wireless starter kit plus 6 smart TRVs. S-Plan heating system with 2-valves upstairs in the water cylinder…
-
TRV temperature measurement
Maybe I'm wrong, but considering that TRV are 5 cm away from the radiator, the measurement on the temperature makes no sense. Given that it is so near the temperature there is going to be always 2 to 3 degrees over the rest of the room For example I have a 6 sq meter room with one radiator and the Tado TRV and I've set two…
-
Tado bridge positioning
I am new to Tado and trying to get to grips with it. Problem so far is that when we leave the house, after a short while the system reads as offline on the app. The issue is flagged as being that receiver is offline. I believe problem is with Bridge positioning because next day I placed bridge differently as a test and it…
-
Smart scheduler switches to "off" at the end of each time block
I'm having all sorts of problems with the Smart Scheduler. In particular it switches to "off" at the end of each time block rather than do what has been programmed. I have a very simple arrangement, no geofencing or anything like that. Any ideas?
-
Reconnecting after internet stop outs
I am having issues with my internet often dropping out. When reconnecting the internet bridge does not connect automatically and does not link with the devices.
-
Do I need a bypass valve _and_ an expansion vessel, with TRVs on all radiators?
I have a Tado setup, and I'd like to put TRVs on all my radiators. I've read many posts around here mentioning that when you have TRVs on all radiators, a bypass valve is needed, to avoid overloading your boiler pump (when all TRVs are closed, yet the boiler is still pumping). However, I've consulted my boiler's manual…
-
Hot water on combi boiler
I recently had the Tado Starter Kit with Hot Water extension installed to my Alpha EcoPlus combi boiler when I was having my annual service. The heating side works fine but I’m having issue with hot water. I’m aware with a combi hot comes on when I turn on the tap, my issue is with the temperature. The temperature is now a…
-
Constant problems with Tado
I posted about my wireless receiver not communicating with the app before. I was advised to move the bridge which I have done following all the instructions given on the troubleshooting. The bridge is away from the router and not against a wall or between furniture. My taco devices are more than 3 metres apart. This…
-
App not sending Signal to the Wireless Reciever
Today my heating wasn’t on when I got up. The App was offline and I fixed that then discovered that although the app said the heating and hot water were on, they were in fact not on. It took me all day to finally fix this by deleting devices off the app and adding them again and also deleting the app. I’m just wondering if…
-
Inaccurate temperature readings
Good morning My Tado TRVs and the main Smart Thermostat consistently over-estimate the temperature. The TRVs are miles out. I placed another small thermometer right next to the TRV, so that it was measuring the same location and the TRV measured two or three degrees warmer than the non-Tado thermometer. My Smart Thermostat…
-
App issue - can’t access rooms
Anyone having an issue with iOS app when trying to go in to specific rooms to change their temp. I just getting spinning wheel and nothing happens. Installed and reinstalled but not resolved. Any thoughts welcome TIA
-
Interaction wired thermostat and smart radiator thermostat
I have a wired thermostat that works ok and I have now added a two smart radiator thermostats which also appear to be ok, they are in a single zone controller which is the wired thermostat. Question is the wired thermostats (WT) has time blocks 05:00 to 09:00 can the time blocks for radiator thermostat (RT) if set for say…
-
Tado vs Netatmo modulating thermostat
Did anyone got the new Netatmo modulating thermostat? On the paper looks ok but Tado also look ok on paper and advert’s before to buy! In reality not so smart as advertised but Netatmo claim to learn and don’t know if still a sale gimmick as Tado’s wisdom!
-
What to do with the TADO room stat ?
I fitted a TADO room stat etc to control my boiler and everything works ok, i then fitted TADO radiator TRV's to every room and they work 100% ok, very pleased with the level of heating control i know have. So my question is , now i have TADO control on every radiator, what do i do with the room stat, does it need to be…
-
Constant Low Battery Alarms. Defective Tado batch thermostats or defective Tado software?
Low battery alarms even on the day of first install. From all radiators in the house on different days. Tried changing batteries to new alkilli cells but still persists. Removed batteries all well above 1.5V on test. What is wrong with the design?
-
9 Smart Radiator Thermostats bought, installed and now defunct! (Pegler)
Hi all, Recently moved in to a new home that I'm hoping to try and future-proof by installing a lot of smart home kit. Invested quite a bit in Tado products, and after sending this image to Tado support to ask which 'adapter' from the packet needed to be used to install on the valve, they told me that it was fine to just…
-
How do I use the app to select when to heat the domestic hot water?
During daylight hours I use excess electricity from my solar pv to heat the water, so I only want the boiler to top up at the end of the day.
-
"early start" functionality suddenly enabled
Hello, today (february 9 2023) I noticed the 'Early Start' functionality was suddenly enabled in our smart schedule. We have the tado app installed on our (two) phones, but none of us enabled that functionality ourselves, we're 100% sure. I do remember there were 2 app updates available in the google play store recently…
-
Tado Wired Thermostat v3+ & Worcester Bosch Greenstar 30 CDi existing programmer
Hello, Just after some advice, I have a Worcester Bosch Greenstar 30 CDi which has a built in programmer to set time periods when the system operates. I want to make things more flexible and looking to use the Wired Thermostat Kit v3+ to replace my existing honeywell thermostat which is a standard two wire low voltage that…