-
Which System?
Hi, We've moved into our new build home about 10 months ago and are now thinking about installing a Tado system but I'm not sure which I require. At the minute we have a Valliant ecoTEC sustain 28 VUH 286/7-2 combo boiler and a hot water tank which I'm looking to control. We have a hard wired thermostat located in our…
-
My Android App asks me to login everytime
Is anyone else having issue with having to log on everytime you load the Tado App in Android?. It's very annoying and appears to have started only this week
-
Could use some help to gain efficiency (35%)
Good evening all I am seeking some of the help to get my setup right. I got Ideal Vogue 32 Max in my 3-bedroom house. I run it with a total of 11 radiators. My heat loss calculation seems to be (if I have done it right) at about 6.7kW. I got Tado Wireless kit (EU version) and it is plugged in and configured for OT. I do…
-
Zigbee Thermostat
One question, can the Tado controller connect to Zigbee 3.0 Thermostats?
-
Thermostat direction
Hi, I think I may have installed some rad thermostats as vertical stats and not horizontal, anyone know how to check in the app?
-
Existing Tado Installation - now suddenly Heating not working?
Hi All, My set up is a Vaillant EcoTEC Plus 424 Boiler (Water tank in attic and cylinder in airing cupboard). Gravity Fed system. I installed a wired receiver (below boiler), wireless thermostat (in hallway) and 10 x smart TRV's (note: i also have approx. 6 non smart TRV's on other rads in the house). I installed all this…
-
Heating off but TADO sending constant "Switch Live" to boiler
Summertime, so heating off, but my boiler constantly running and bathroom radiator always warm. I have a Baxi DuoTec combi boiler, starter kit, plus 8 Smart Rad valves on all rooms except bathroom - which is set to on/open. Recently, my boiler pump has started running constantly, with the boiler firing up periodically.…
-
Modulation with Multi Zone
I am looking to purchase a Valliant Ecotec 938 or Veissman 111-w. This will drive 1 zone of radiators and 2 UFH zones (via 2 port valve). I am thinking to go for the Tado 3 Wireless EU version to modulate the radiator zone via eBus/OpenTherm. I assume I would need 2 wired thermostats for the 2 UFH zones. Would the wired…
-
Verhalten bei temporär abgestellter Heizung
Hallo, morgen wird bei uns zwischen 09:00 und 16:00 Uhr die Heizung aufgrund von Wartungsarbeiten abgestellt. Muss ich die Thermostate ausschalten, damit die nicht krampfhaft versuchen hoch zu heizen? Grüße HagenB
-
Incident detection did not work in Care&Protect
Hello I’m new to Tado community (just bought my first starter kit this month), so I might miss answers on this topic. Some days ago, I was away from home and set the Tado on Off mode. In the day of my return, I remotly set the Tado to Auto scheduling, to start heating the house for the time I’ll arrive. The problem was…
-
Do i need to replace EPH controller in order to use Wireless Thermostat.
Firstly, VERY HAPPY to have found this community, google wasn't helping much. I currently have EPH 37HW (3 channels) 1 Upstairs 2 Downstairs 3 HW. I do not use the HW zone as i have a seperate timer on my roof hot water system. My 2 current thermostats are next to the back door and in an upstairs hall way, neither are…
-
Whistling tado
Now and then, mostly early mornings and late evenings, after the temperature is set to change, one of my Tado whistles loud and the other softly. Another three do not whistle at all. If I press the Tado round front piece inwards, the whistling pauses, then resumes when I let go. I have a video of this but I am not sure how…
-
Some Radiator Thermostats not responding to geofencing Away
I have 8 rooms set up with Tado radiator stats. When I click Geofencing away, 3 rooms do not respond. Do I have to set up those room stats again?
-
Random app log out
Does anyone else randomly get logged out of the Tado app? Seems to happen to me quite often ; got to open it and then need to resign in and reclaim device etc. Is this just a security thing in the app or is it an issue with the app itself (or maybe my phone?!)
-
Smart AC control v3, dry mode, IFTTT
This is probably a question better addressed to my air con manufacturer Daikin, but they didn’t know! I was thinking of using IFTTT and the smart AC control to manage humidity levels in my vacation rental during the winter when the house is typically empty. Eg when humidity >60% turn air con DRY mode on. I wondered if…
-
Nest UFH Tado Rads ?
Hi I’ve got a Worcester system boiler currently connected via a Honeywell junction box to 3 Honeywell diverter valves 1 for UFH, 1 for rads and 1 for HW Currently I have a nest heatlink / wireless thermostat to control the rads and a nest heatlink / wired thermostat which controls the UFH and hot water Can I replace the…
-
Boiler keeps firing when switched off
My boiler is a Baxi WM382 RS. It keeps firing up even though the tado is timed off. Is there something wrong with the wiring
-
No heating only hotwater then heating works when hotwater on aswell as heating
The hot water works as it should and 'fires up' my boiler but there is no heating whatsoever. The thermostat appears to be working inasmuch as it seems to be sending a signal to 'fire up' my boiler but even when the boiler does make an initial attempt to work, the burner light does not continue to stay on for longer than a…
-
Loss of Internet
I know this has been mentioned before, but last night the internet went down, and this morning I awoke to a nice warm lounge. The current settings were maintained. I do not know if there is any firmware in the controller to carry on the pre programmed schedules in the event of an internet outage, but in my opinion there…
-
Correct adapter to use for my radiator?
Hi, I would like to fit a tado smart radiator thermostat on an ultraheat radiator in my house. I am unable to fit it on with the default adapter. Which adapter should I use for the radiator in the images below: Regards,
-
Does Tado turn the boiler off when it reaches temperature?
Hi, Please can someone help. Last night, I had Smart Schedule going and two of the radiators were on, and it showed in the Tado app. However, after not a very long time after the evening schedule started, the boiler was no longer firing and the heat slowly died away from the radiators, even though it said they were on in…
-
Importing rooms into HomeKit
Hello Is there a way to import rooms into HomeKit? It’s pretty annoying as all my Tado devices come up under “Default Room” in my Apple Home!
-
Wireless Receiver Wiring for 230V zone valve
Hi, I have a Wireless Receiver (V3+) that I want to use to control a zone valve that operates on 230V. I think the wiring from this diagram should do the trick. It gives 230V to the valve when there is a heat request and no voltage to the Valve when there is no heat request. However, the Valve seems to be always open…
-
TADO Wireless Receiver
I have installed device , to a Combi boiler Followed instructions , step 6 Configuration Got the Orange light up and confirmed via test button after 5 secs It will not save + reverts to white light Tried a few times Please advise help/remedy Scott
-
How to use A temperature sensor and Smart TRVs
Hi! I’m a complete newbie so any help is appreciated. I live in a very cold exposed Bath Stone house with no consistent level of temperature in each room and some rooms have 2 or 3 radiators with traditional TRVs. Temperature sensors and Smart TRVs in these rooms seem a hugely costly outlay. Can the temperature sensor…
-
Boiler making strange noises
Since installing the tado thermostat and programmer, my Potterton boiler makes strange noises when heating up. Is this normal behaviour?
-
TADO Wireless receiver Device - Wiring issue
I have a Baxi105HE Combi the Op manual ( JPEG extract attached) 7. To connect external control(s) remove the link between terminals 1 & 2. The 230V supply at terminal 1 , must be connected to the external control. The switched output from the external control must be connected to terminal 2 (Fig. 43). I believe this is…
-
Why is my Smart Schedule not turning my heating on or off ?
My Smart Schedule is not turning my heating on or off. I can change the temperature manually on the App but the smart schedule will just not work. Any ideas ?
-
New to Tado
Got radiator valves up and working, however when adding wireless receiver, the home page is populated with HotWater icon, this then throws up an e12 error, cannot get hot water to work as a separate output from the wireless receiver
-
Temperature Offset
Where is the temperature Offset menu?