-
Gloworm boiler
Has anyone connected to a gloworm boiler yet with extension kit? If so how?
-
Tado app
I have an iPhone 5s and tado app won’t download on it. Do I have to buy a new phone?
-
Tado heating 'offline' with Google home app telling me to 'Check your network connection'.
Not used the voice command for a while so do not know how long this has been like this. When asked to set the Tado heating I got the following messages (amongst others) 'I couldn't reach Tado degree' or 'Sorry that mode isn't available for the heating'. Checking the Google Home app on my phone shows the image included…
-
combine floor heating & radiator for constant temperature?
Hi, We're considering a smart system for our home but can't figure out if Tado could manage our situation. We'd appreciate your advice: The most important reason for wanting a smart system is the fact we're having a baby and we'd like the babyroom to be a constant temperature. The issue is that this room has both floor…
-
Additional Room Thermostat
I have a tado smart stat in the hallway on the ground floor. My ground floor rads do not have trv's but my 1st floor rads do and the system works fine, however during the night I would like to allow my kids rooms to call for heat without the downstairs warming up too. If I add a Additional Room stat on the 1st floor and…
-
Additional room stat
I have my radiators controlled by smart TRV's and a room stat in the hallway. Can I add an additional room stat in another room to the system?
-
Wi if extender
Is there any way that an ordinary Wi-fi extender would extend the range of the internet bridge allowing t to connect to a radiator valve that is on the limit of distance for receiving signal from the bridge.
-
Existing Remote Room Stat
My current heating system is setup as a zone on ground floor and a zone on first floor. Ground floor has a Honeywell CM907 combined programmer/stat, and first floor has the same programmer but we have a remote wired stat in a different room. I want to install the Tado system in my house so the starter kit should cover the…
-
Black pin in Tado valves Error - see picture
Hi, I have 16 Tado valves and 4 of them are not pushing the black pin far enough out to stop the water from entering my radiator when it is on OFF. See picture http://bit.ly/tado-problem (it is een picture on my google drive, made a bitly from it to keep it short) On that picture you see the left is working good, the right…
-
is this company still operating. I cannot get in touch
I have been on the chat line since earlier in the year with lots of questions about the system. When we bought all the hardware to install the system - including 18 smart radiator thermostats, I tried very hard to get questions answered about installing. They just kept coming back with more and more questions about my old…
-
thermostat always showing manual mode and the smart schedule does not seem to work
thermostat always showing manual mode and the smart schedule does not seem to work
-
radiator adaptors not compatible with my radiator
none of the radiator adaptors fit my radiator. what can i do please
-
A radiator thermostat is not working but shows the battery is ok
what is going wrong. It is turning on in line with house thermostat
-
assign a room
why cant i assign a room there is no rooms in settings in my home app
-
Tado Smart AC location
Hi there, I renovating my flat now and planning to install AC, as well as a Tado Smart AC device. Unfortunately, due to the layout of the flat, I won't be able to place it directly in front of the AC unit. The AC unit I'm planning to get is a Gree Lomo Luxury, which has the IR receiver on the front side. Has anyone tried…
-
Smart Thermostat installed after the Smart Radiator Thermostats
I installed radiator thermostats and used them under control of my original room thermostat to activate the boiler. I have now replaced that with a Tado Smart Thermostat and wired it in and whilst it correctly controls the boiler (calls for heat) when its manual heat is turned up none of the radiator valves work through it…
-
Variable fan speed in thermostatic mode
I was trying to setup my Tado Smart AC Control V3+ in Thermostatic mode, following the recommendations how to train the control, ie "low fan speed" in heating mode. Primarily I'm using my AC in heating mode. My house has a lot of open space which allows me to put the controller in an adjacent room to where the AC is…
-
underfloor heating manifold
is there a tado system compatible with underfloor heating and will the thermostats work on the manifold instead of the rads ? thanks mv
-
My smart thermostat says it is out a charge
Smart thermostat says out of charge but on the app it says its fully charged. Never go given anything to charge it with. Should.i have gotten something for this.
-
Android Geofencing Nightmare
For some reason, I cannot get Geofencing to work correctly on both my wifes and my own Android phone, it randomly forgets we are at home and turns the heating and hot water off without us realising! My wife has a Mate 10 Pro, I have Mi 9T Pro. On both settings I have set battery optimisation off for the app. I have given…
-
Problem with V3+
My system was working fine with v3. I upgraded to v3+ and now it’s not working. What have I missed? Alas I’m not able to go back to V3.
-
Problem with V3+
My system was working fine with v3. I upgraded to v3+ and now it’s not working. What have I missed? Alas I’m not able to go back to V3.
-
Tado not talking to the boiler. Radiators not on
Hi app is talking to the thermostat but the boiler is not responding
-
replacing optima d4 valve
replacing optima d4 valve required fitting
-
Geofencing query
I will be away from home next week but need to leave the heating on it’s normal schedule rather than away. Is there a simple way to ensure the heating remains on for my guests.
-
How to create/denote a second heating circuit?
I have two heating circuits in my home - each controlled by a legacy thermostat. I have replaced one of the thermostats but was directed to Tado support when attempting to add the second thermostat on the other circuit. I have yet to receive a reply to ticket 1034224 Can I do this myself? How do I create a second circuit…
-
What kind of valve do I have?
I just received my Tado v3. But when I wanted to install it I couldnt figure out what adapter I had to use or make one fit. Does anyone know what I should do with my valve? I live in the Netherlands if that helps.
-
Cant connect Smart Ac Control V3 to HOMEKIT
Hi , I can't connect my Tado Smart Ac Control V3 to my HOME KIT on my iPhone . I get this message below " Device not found " ; Iphone 6 IOS 12.4.2 Router wireless 2.4 Ghz Can someone please help me out ? .. I have tried everything , and I have other devices working fine with HOMEKIT ... thanks .
-
Tado not working
I have thermostats in my whole house. The app states the heating is on but nothing works. The radiators are cold. I'm so fed up of this.
-
installation with 2 zone valves ????
Hi, i am currently having an extension and am having underfloor heating fitted. the original part of the house is running a nest on a combi boiler, with traditional radiators. The underfloor heating installer has said i will be best to split the feed and have a thermostat (controlling a zone valve) for the original system…